The Profile Design Flip Ergo 52a is a clip-on aerobar for road bikes that addresses a common issue with conventional armrests: access to the tops of the drop bar. Its spring-loaded Flip armrests lift up and out of the way when not in use, allowing riders to hold the bar tops, including while climbing. The system uses a 31.8 mm clamp and can fit 26.0 mm handlebars with shims.
This Profile Design aerobar combines the Flip bracket with Ergo armrests and 10 mm pads. The 52a aerobar extensions encourage a neutral wrist angle. Riders can adjust extension width, length, rotation, and tilt; extension length and rotation are adjusted using the bottom bolt.
The armrest kit provides a wide range of fit settings. Armrest width adjusts from 112 mm to 280 mm in 18.5 mm steps when the extensions are set at 100 mm, while armrest offset adjusts from -85 mm to -17.5 mm in 7.5 mm steps. Armrest stack is 40 mm, supporting a low-stack riding position.
Finished in matte black, the Flip Ergo 52a weighs 587 g. Its flip-up armrest design and adjustable aerobar extension setup make it a configurable option for riders seeking an aerodynamic position without giving up bar-top access.
- Spring-loaded Flip armrests raise up and out of the way for access to drop-bar tops
- 52a aerobar extensions encourage a neutral wrist angle
- Ergo armrest kit includes 10 mm pads
- Adjustable armrest width: 112 mm to 280 mm with extensions at 100 mm
- Adjustable armrest offset: -85 mm to -17.5 mm
- Adjustable extension width, length, rotation, and tilt
- 31.8 mm clamp diameter; compatible with 26.0 mm bars using shims
- Matte black finish; 587 g weight